Offline:
Name
Email
Username & email is correct, proceed else enter yours
Powered By: EmmasonTalkSys
0
0
0
Format: Microsoft Word (.docx): Pages: 50+ pages: Chapters: 1-5
The full software or material containing all the chapters is available only when you make payment

Category: Project Material

PRODUCTION OF ALKALI USING LOCAL RAW MATERIAL(PALM INFORESCENCE)

Abstract/Description


The project aims to develop a flow process to obtain the optimum temperature and time necessary for the maximum recovery of alkali present in palm inflorescence. On this ground, a preliminary experiment was performed. During this process, both male and female palm inflorescence were compared for maximum alkali production and it was observed that the female palm inflorescence produced highest quantity of alkali than the male palm inflorescence. Based on this, the female palm inflorescence was used in performing the experiment. Also, experiments were carried out to determine the optimum temperature and time for maximum alkali recovery. After the analysis and analytical calculations it was found that the optimum temperature for maximum alkali production is 4500c and the corresponding time for the production is 90 minutes.

Service Charge: NGN3000

|

Note: You can also make payment to any of the bank details at the bottom of the this page then verify your payment.

Other topics related to this department
THE EFFECT OF ENVIRONMENT ON CORROSION
PRODUCTION OF PLASTIC MATERIALS
ANALYSIS OF CRUDE PALM OIL
DESULPHURISATION KEROSENE
TEMPERATURE AND WATER REQUIREMENT FOR LEACHING OF CAUSTIC ALKALI FROM ‘NGU’
PRODCUTION OF WOOD ADHESIVE
PRODUCTION OF ALKALI USING LOCAL RAW MATERIAL(PALM INFORESCENCE)
EXTRACTION OF OIL FROM LOCAL SEED (GROUNDNUT SEED) & CHARACTERIZATION
MANUFACTURE OF CEILING BOARD USING LOCAL MATERIALS
PRODUCTION OF BLACK AND BROWN POLISH
PRODUCTION OF HIGH QUALITY FOAM